Forum › MIFARE SDK › Tag was lost error › Reply To: Tag was lost error
Hi JM,
NTag uses ISO14443-3 protocol. In this protocol the tag goes into a “halt state” when an error occurs. This means no communication anymore and no error message back (this is detected as “tag lost”).
You should start your session with commands which always success like read a page which is available and always readable.
The TapLinx team
NTag uses ISO14443-3 protocol. In this protocol the tag goes into a “halt state” when an error occurs. This means no communication anymore and no error message back (this is detected as “tag lost”).
You should start your session with commands which always success like read a page which is available and always readable.
The TapLinx team
+ 0
|
- 0