Forum Replies Created

  • Re: Reply To: Best MIFARE Reader chip for battery powered appliations

    30. December 2019 at 7:59
    in reply to: Best MIFARE Reader chip for battery powered appliations
    Thanks for the support. Where can I get a MOQ quotation for 1000pcs for the MFRC630?
    + 0  |  - 0

    Re: Reply To: Best MIFARE Reader chip for battery powered appliations

    11. December 2019 at 12:23
    in reply to: Best MIFARE Reader chip for battery powered appliations
    Hi,

    Thanks for the information. The third url seems invalid, says page not found.
    Are there any hardware design application notes for the MFRC630 reader, besides the antenna design ones or is there any reference design schematics available for the same?

    Thanks
    Brosnan
    + 0  |  - 0

    Re: Reply To: Best MIFARE Reader chip for battery powered appliations

    5. December 2019 at 15:18
    in reply to: Best MIFARE Reader chip for battery powered appliations
    I agree with you on the type of operation mode part.
    I was looking at the MFRC522 and the MFRC630. I was tempted to go with he MFRC522 because of the cost and wide range of documentation available, but it lacked the LPCD mode which cannot be done without in a battery application i think. I'm looking at 4 AA batteries to be running the Micro-controller + Mifare chip over a year, if that is possible with firmware optimization. Hence was looking at the MFRC630. Am I going the correct route? Please suggest more ideas.

    Thanks
    Brosnan
    + 0  |  - 0

    Re: Reply To: Best MIFARE Reader chip for battery powered appliations

    4. December 2019 at 12:09
    in reply to: Best MIFARE Reader chip for battery powered appliations
    Sorry Missed the word "chip" there. Which MIFARE chip I should be going for?
    + 0  |  - 0
Viewing 4 posts - 1 through 4 (of 4 total)