MFRC630 Anti-Collision Cycle Issue

Forum / MIFARE and NFC Reader IC`s / MFRC630 Anti-Collision Cycle Issue

Tagged: 

  • 19. June 2019 at 13:08

    Gideon Potgieter
    Hi,


    I'm writing firmware to drive an MFRC630 chip.

    So far, I've got the REQA/WUPA routine down--when I present an NFC tag to the reader:
    MCU sends 26H and get 44H 00H back.
    MCU sends 52H and get 44H 00H back.

    Then, during the first anti-collision cycle, something goes wrong:
    MCU sends 93H 20H and get 20H 00H 00H 00H 00H back (instead of 20H SN0 SN1 SN2 BCC0), where SN1, SN2, and SN3 shouldn't be non-zero values.

    Does anyone have any idea why this might happen? Any advice would help.


    Kind regards,

    Gideon
    + 0  |  - 0

    Re: MFRC630 Anti-Collision Cycle Issue

    19. June 2019 at 13:09

    Gideon Potgieter
    My apologies. In the original post, I meant "SN1, SN2, and SN3 should be non-zero values." Not shouldn't.
    + 0  |  - 0
  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.