Forum › MIFARE SDK › Mifare Desfire ISO SELECT FILE Command › Reply To: Mifare Desfire ISO SELECT FILE Command
Hi,
Looks like my question was not clear. The feature that is explained in that section of the document is not available in native commands. Indeed that is a very good feature the document says this. When we select a application not only we get status 90 00 but also the content of a file with id 31 in that application folder.
With native command I have to do two separate request to achieve this. All I am asking is, since the document mentions about this feature of ISO commands, I could not reproduce it. If anybody in your tech support have done this, then I would like to know how?
regards
NarenDC
Looks like my question was not clear. The feature that is explained in that section of the document is not available in native commands. Indeed that is a very good feature the document says this. When we select a application not only we get status 90 00 but also the content of a file with id 31 in that application folder.
With native command I have to do two separate request to achieve this. All I am asking is, since the document mentions about this feature of ISO commands, I could not reproduce it. If anybody in your tech support have done this, then I would like to know how?
regards
NarenDC
+ 0
|
- 0