Forum › MIFARE SDK › Switching MiFare Plus to S3 › Reply To: Switching MiFare Plus to S3
Hi Rafael,
The error message says that the data block used is not a multiple of the block length. For AES128 this is 16 bytes. If your data block is less than 16 bytes you have to fill it up. You can do it automatically if you use “padding”.
Regards,
The TapLinx Team
The error message says that the data block used is not a multiple of the block length. For AES128 this is 16 bytes. If your data block is less than 16 bytes you have to fill it up. You can do it automatically if you use “padding”.
Regards,
The TapLinx Team
+ 0
|
- 0