Reply To: DESFire EV1 SelectApplication Command

Forum MIFARE general topics and applications DESFire EV1 SelectApplication Command Reply To: DESFire EV1 SelectApplication Command

Re: DESFire EV1 SelectApplication Command

3. March 2016 at 11:10
Hi Jan,

I can select the same application AID again and again. It makes no sense to do that, but you can do it without to get an error. But if the AID does not exists, then an error occurs and you can get into an error state and have to come out only if you start a new selection sequence again. But this depends on your underlying interface/driver system.

Do you have checked that the AID really exists? You can check the existence with the command GetApplicationIDs() .

The MIFARE Team

+ 0  |  - 0